grandMA3 User Manual » Fixture Types » Build Fixture Types » Link Models to Geometry

Version 2.0

The offset of the position depends on the measurements of the models. 

Requirement:

• Insert Geometries and Insert Models.

1. Tap the tab Geometries.
2. To link the model Base to geometries, tap, and hold the cell in the column Model.

• Pop-up Select Model opens. 
• Select Base.

3. Set the offset of position in single geometries.

• In Base, leave the default value of Pos Z.
• In Yoke, set Pos Z to -0.265 m.
• In Head, set Pos Z to -0.100 m.
• In Beam, set Pos Z to -0.150 m.  

This is the result in the 3D window.