dot2 provides an operating system that is independent from the web remote interface. To connect the web remote to your dot2 console, make sure your tablet or computer network interface has the same subnet as your console.
Important:
Use one of these web browser versions to run the web remote on your PC, smartphone or tablet:
-Internet Explorer 10
-Safari and iOS 8.1
-Opera 26
-Chrome 31
-Chrome for Android 39
-Firefox 33
If the browser you use does not meet at least the minimum of the requirements necessary for the usage of the web remote, an HTML fallback page will be displayed.
Hint:
It is possible to connect up to three web remotes to one console.
Hint:
It is also possible to use the web remote on the dot2 onPC.
Connect the web remote:
Enable the web remote in Setup – Global Settings.
Tap the prohibition sign to check the green box in Web Remote.
Type the IP address (see in the brackets) of the dot 2 console into your web browser.
The window Web Remote opens.
Type the default password "remote".
Figure 1: Enter password for web remote
Tap Login.
It is possible to adjust the display of the web remote to the device you use.
To do so:
-Tap Main Menu.
-Tap Settings.
-To display the web remote on a smart phone, tap Phone.
The web remote fits now the display of your smart phone.
Figure 2: Web Remote – Setting "Phone"
-To display the web remote on a tablet, tap Tablet.
The web remote fits now the display of your tablet.
Figure 3: Web Remote – Setting "Tablet"
Web Remote Password
To change the password of the web remote on the console:
Press Setup
Tap Global Settings.
For more information on how to change the eth0 IP on the console see the command SetIP.
