Create a chaser

To create a chaser, create a sequence with at least 2 cues assigned to an executor.

1. Change the sequence to a chaser by pressing Assign and one of the keys associated with the executor.
2. This opens the Assign menu. Tap Options on the right side.
3. To change the sequence to a chaser, tap Chaser located below the tab Function.

The mini executor is now cyan.

It is possible to change the functions of keys and fader associated with the Executor. For more information, see Assign a function.

All timing and loop information in the sequence is ignored. Commands (CMD) are executed and the CMD Delay is the only timing from the sequence that is actually used. For more information, see​ Commands in cues.

---

Start, Stop and Pause the Chaser

• To start the chaser, press Go+ and one of the keys associated with the executor. To fade in the chaser, press Go+ Time and the fade time in seconds, for example 5.
• To stop the chaser, press Off and one of the keys associated with the executor. To fade out the chaser, press Off Time and the fade time in seconds, for example 5.
• To pause the chaser, press Pause. The chaser stops in the current step and contains the output from this step. To start the chaser again, press Pause once more.